Journal of Radiation Safety and Measurement

Journal of Radiation Safety and Measurement

A new multistage etching method for calibration of CR-39 nuclear track detector for alpha particles spectroscopy

Authors
farbod Bahrami
fereydoon abdolah mianji
mehran taheri
reza faghihi
10.22052/3.1.1
Abstract
In this paper, application of the CR-39 passive nuclear track detector for spectrometry of alpha particles is investigated. To this end, a standard Am-241 source as the alpha radiation source, and brass collimators with different heights for energy determination of alpha particles were utilized. The detectors were irradiated by alpha particles in the energy range of 0.8 to 4.8 MeV and then were etched by sodium hydroxide solution in the temperature of 85 ℃ based on the multistage etching process with 1.5 hr etching time intervals. The experimental results showed that by increasing the etching time, the maximum track diameter happens in the higher energies of alpha particles. Owing to the occurrence of the overlap effect in the “alpha energy-track diameter” curve for insufficient etching times, experiments were carried out to define the minimum required time for efficient spectrometry over the alpha energy range of 0.8 to 4.8 MeV. It is shown that by increasing the etching time to 10.5 hr the overlapping effect can be overcome for the mentioned energy range and a practical diagram for alpha particles spectrometry in unknown fields can be obtained. Also, the detection efficiency of this method for alpha particles was measured to be near 100%.
Keywords
Track dosimetry
Track diameter
Etching solution
Alpha spectrometry
[1] D. A. Young. Etching of radiation damage in lithium fluoride. Nature. 182 (1958) 375. [2] B.G. Cartwright, and E.K. Shirk. A nuclear track-recording polymer of unique sensitivity and resolution. Nucl. Instrum. and Methods in physics research. 153 (1978) 457-460. [3] A. Majeed, F. Humayon, S. M. Ahmad, S. A. Durrani. A simple technique to discriminate various charged particles using SSNTDs. Nucl. Track and radiat. Meas.22 (1993) 679-682. [4] D. Nikezic, k. N. Yu. Formation and growth of tracks in nuclear track materials. Materials Science and Engineering. 46 (2004) 51-123. [5] D. A. Young. On the mechanism of the formation of latent tracks in dielectric solids. Radiat. Meas. 27 (1997) 575-586. [6] A. H. Smail, M. S. Jaafar. Design and construct optimum dosimeter to detect airborne radon and thoron gas. Nucl. Instrum. 269 (2011) 437-439. [7] A. H. Khayrat, S. A. Durrani. Variation of alpha-particle track diameter in CR-39 as a function of residual energy and etching conditions. Radiat. Meas.30 (1999) 15-18. [8] A. Peter, D. L. Henshaw. High resolution alpha particle spectroscopy using CR-39 plastic track detector. Nucl. Instrum. 197 (1982) 517-529. [9] M. E. Ghazaly. On alpha particle spectroscopy based on over-etched track length in PADC (CR-39 detector. Radiat. Effects and Defects in Solids, 167 (2012) 421-427. [10] M. Sohrabi, Sh. Mahdi. Background heat treatment studies in LR-115. Nuclear Tracks and Radiat. Meas. 12 (1986) 149-152. [11] W. Enge. Introduction to plastic nuclear track detectors. Nuclear Tracks and Radiat. Meas. 4 (1980) 283-308. [12] M. F. Annuziata. Handbook of radioactivity analysis, Academic press, (2003).